Vicon CE102D Guía de instalación descargar pdf (Pagina 50)

 RTP

Create a setting for sending and receiving video on a real-time basis. These settings are the IP

address, port number, and Time-To-Live value (TTL) to use for the media stream(s) in multicast

H.264 format. Only certain IP addresses and port numbers should be used for multicast streams.

• Port Range

- Start/End port: Enter a value between 30000 and 39920

• Multicast

This function is for sending video to multicast group.

- Enable Multicast: Check the checkbox to enable multicast operation.

- Multicast destination IP: Enter an IP between 224.0.0.0 and 239.255.255.255.

- RTP port: Enter a value between 1024 and 65530.

- RTP TTL: Enter a value between 1 and 255. If a network status is smooth, enter a lower

value. However, if a network status is poor, enter a higher value. When there are

many network cameras or users, a higher value may cause a heavy load to the network.

Consult with a network manager for detailed information.

- Always enable multicast: Check the box to start multicast streaming without opening an

RTSP session.

When the settings are complete, click Save, or click Reset to revert to previously saved settings.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 70 71

Sin comentarios

Vicon CE102D Guía de instalación Pagina 50