Vicon Roughneck V920D Series Guía de instalación descargar pdf (Pagina 11)

Torx screws

M5x10 (4x)

Accessory Kit

There is an accessory kit included with the Roughneck V920D-IP. The table below lists the contents.

Description Quantity

Torx wrench (to remove tamperproof screws)

Pipe sealant tape (to seal pipe fitting to housing)

Screws, anchors and rubber washers (for some

appropriate installations)

4 of each

Vent plug (for outdoor installations) 1

Terminal blocks, 3-pin (24 VAC power); 4-pin (alarm

output); 2-pin (RS-485; UTP option)

1, 1, 2

Cable access plug (black; for rear hole)

Cable access plug and tool (threaded; for side hole)

1 of each

Grommet (for routing cable; rear access)

Mounting the Unit

Select a location for the installation of the V920D-IP camera. Be sure the area around the selected

location is clear of obstacles (such as steel beams, headers, pipes, electrical wiring, etc.) which would

interfere with the mounting of the camera and that the location can support the weight of the unit

[the V920D-IP unit weighs 2.5 lb (1.1 kg)]. Video and power cables must be routed to the installation

location.

The V920D-IP mounts directly to a ceiling or wall. The base has four mounting holes; two cable

access holes are provided. As a mounting alternative, the mounting holes align with a standard 4 x 4

electrical box for mounting; an adapter plate is available that creates an aesthetically pleasing

appearance (model V910/V600W-PLATE). Refer to Mounting Hole Figure that follows. To mount the

V920D-IP, follow the steps below.

Caution: Do not attach these units to drywall surfaces and do not install mounting screws into the

end grain of wood.

1. Loosen the four (4) Torx screws securing the cover; leave the screws intact. The cover is

attached to the base by the safety cord upon delivery. Allow the cover to hang.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 81 82

Sin comentarios

Vicon Roughneck V920D Series Guía de instalación Pagina 11