Vicon Roughneck V920D Series Guía de instalación descargar pdf (Pagina 17)

Connect the ground side of the alarm input and/or alarm output to the G (Ground) connector.

Alarm Out:

The network camera can activate external devices such as buzzers or lights. Connect the device

to the AO (Alarm Out) and G (Ground) connectors.

Connecting Audio

Use the optional

V920D-AUDIO cable assembly for ease of audio connections. The cables are labeled for

Audio In and Audio Out. Refer to diagram below.

Audio Out: Connect wire 1 and ground to speakers.

Audio In: Connect wire 2 and ground to microphone.

• Connecting the Power

Connect the power of

12 VDC or 24 VAC for the network camera. Connect the positive (+) pole to

the ‘+’ position and the negative (-) pole to the ‘-’ position for the DC power.

 Be careful not to reverse the polarity when connecting the power cable.

 A router featuring PoE (Power over Ethernet) can also be used to supply power to the

camera.

 The heater can be powered by a 24VAC, 12VDC, PoE power source.

 For the power specifications, refer to the Appendix, Product Specification.

 If PoE and 12 VDC are both applied, the camera will be supplied with power from PoE.

 Heater

The heater comes preinstalled in the camera dome.

Power Supply

12 VDC

Power Consumption

3.5 Watt

Heater On

at 59°F (15°C)

Heater Off

at 77°F (25°C)

• Connecting Service Monitor Port

The Service Monitor output port (J7) is located on the board of the dome camera and is used for

easy OSD setup.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 81 82

Sin comentarios

Vicon Roughneck V920D Series Guía de instalación Pagina 17