Vicon Roughneck V920D Series Guía de instalación descargar pdf (Pagina 18)

▶ ID & IP assignment

To make changes in the OSD menu, the optional OSD controller (V920-OSD) can be used to set

Camera Title and IP Address.

1. Connect the OSD Controller to the Service Monitor port of the network camera.

2. Connect Service Monitor and the Video Output port of the OSD Controller.

3. Press the SET button on the controller to access the Main Menu.

4. Change camera ID and IP address as needed. Additionally, the Name (or title) of the camera

can be changed. Use the ↑↓←→ buttons on the controller to change the parameters.

5. Select SAVE or CANCEL to exit the Main Menu.

The Video Output can also be used for easy zoom and focus control when adjusting the lens.

Video Output is restricted to 704x480 (576) resolution.

▶ Zoom & Focus Control (Models with motorized lens only)

The camera enters Zoom and Focus control mode when the OSD Controller is connected to the

Service Monitor port.

-. Zoom Control: ↑ (Zoom In), ↓ (Zoom Out)

-. Focus Control: ← (Focus Near), → (Focus Far)

-. Fine Focus: Press and hold the SET button for at least 2 seconds. The camera readjusts

focus automatically.

Note:

The optional V920D-OSD OSD Controller can be purchased separately.

2.3 Network Connection and IP assignment

The network camera is designed for use on an Ethernet network and requires an IP address for

access. Most networks today have a DHCP server that automatically assigns IP addresses to

connected devices. By the factory default, your camera is set to obtain the IP address automatically

via DHCP server. If your network does not have a DHCP server the network camera will use

192.168.1.100 as the default IP address.

If DHCP is enabled and the product cannot be accessed, run the “Smart Manager” utility on the CD to

search and allocate an IP address to your products, or reset the product to the factory default settings

and then perform the installation again.

1. Connect the network camera to the network and power up.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 81 82

Sin comentarios

Vicon Roughneck V920D Series Guía de instalación Pagina 18