Vicon S10-CH Mini Especificaciones descargar pdf (Pagina 19)

XX134-44-02 Rev 710 SurveyorVFT Camera Dome Programming Programming Menus • 13

The Sector Censoring screen (22XEX/23X/35X cameras only) is designed to

disable the video in areas that do not require surveillance. It is often used to keep

traffic control cameras from looking into the windows of adjacent apartment

buildings, but this feature has many other applications. Sector Censoring goes one

step further, allowing the user to turn off the video for any or all of the 16 sectors. A

black screen with the words “Blank Sector” is displayed until the camera moves out

of that sector and into one where the video is enabled. This function includes a tilt

mask, where the top and bottom of the mask is programmable for each pan sector.

Only when the tilt position is within the programmed mask will the video be

disabled. The default mask covers the entire area (full tilt up and down). Perform

the following procedure to change these limits. The censored sectors are

programmed as follows:

1. Program preset 96 to enter sector programming.

2. Adjust the tilt angle to the top of the area to be masked. Press AUX 2 to set.

3. Tilt down to the bottom of the area to be masked. Press AUX 3 to set.

4. Pan right to the end of the sector and press AP to define, as previously

described. Continue programming each sector up to 16.

5. Enter preset 94, Camera Controller, Sector Censoring to enable or disable the

masked sector.

Note: If AUX 2 and AUX 3 are not pressed for a particular sector, then the mask will

cover the entire tilt range.

Sector Censoring offers sixteen Privacy Masks that block out selected areas of a

scene. The size and position of the block are adjustable using the joystick and A/P

key. The privacy mask provides a zoom level feature, from 1.0X to the maximum

optical zoom of the camera, adjustable in 0.1 increments. With this feature, the

privacy mask will only display if the camera zoom level is greater than or equal to

the zoom level set for the privacy mask. In this way, the mask does not appear on

screen to obscure the view if its zoom level is lower.

Note: Text size and frame positioning affect the privacy mask; refer to those

sections in this manual.

1. Press A/P on Privacy Mask selection.

2. Press A/P at Program Pmask selection.

3. Using the joystick and AP key, define 3 corners of a block.

4. When complete, the Configure Pmask screen displays to program the next

privacy mask.

5. When you exit the menu system, the privacy masks appear. The privacy mask

is zoom scalable.

The default setting for video in all sectors is enabled, which permits video surveillance in all 16 sectors.

6. Press A/P on Privacy Mask Zoom Level on the Systems Setting menu. Use the joystick to select Pmask

number and program Zoom Level. The default zoom level is 1.0X, which means it will always display.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 41 42

Sin comentarios

Vicon S10-CH Mini Especificaciones Pagina 19