Vicon S10-CH Mini Especificaciones descargar pdf (Pagina 22)

16 • Programming Menus XX134-44-02 Rev 710 SurveyorVFT Camera Dome Programming

The Acknowledge Mode menu determines whether an alarm is acknowledged

manually by the operator, momentary so the alarm remains active until the alarm

state is eliminated, or automatically after a predetermined period of time (up to 89

seconds).

Note: In simplex mode, be sure to program the dome to somehow acknowledge

alarms. The system will stop responding to subsequent alarms. In duplex

mode with a Pilot/NOVA system, never set up an alarm set and reset action.

The system will call up the reset action before the set action could finish

because these systems immediately acknowledge alarms. It is

recommended that the Pilot/NOVA systems be used for alarm processing.

The next two menus program what happens during an alarm event. Each alarm is

actually two events, set and reset. In many cases, we can have 4 alarm functions

per dome. Set Actions occur when alarms are triggered. In the example, this

occurs when the door is opened. The Reset Actions occur when the alarm

conditions are removed, in this case when the door closes again. Since each

action may be programmed individually, we can handle many more functions than

are immediately apparent.

The Set Actions menu calls up a sub-menu for each of the four alarm inputs. The

Reset Actions menu calls up an identical sub-menu for the reset actions. Choices

for action upon triggering the alarm are as follows:

• No Action — Nothing happens on this alarm action.

• Preset — Allows any one of the 79 dome presets to be called.

• Turn On AUX — Allows the Relay Driver to be turned on.

• Turn Off AUX — Allows the Relay Driver to be turned off. Please note that

a Set Action can turn on the driver, while the corresponding Reset Action

can turn off the driver.

• Tour — Activates one of the 8 (22XEX/23X/35X) or 4 (22X)

preprogrammed tours. Since a tour consists of up to 32 steps, and a tour

can call other tours, by combining tours with alarm actions, multiple actions

can be triggered from a single contact closure.

• Autotour — Activates one of the 2 preprogrammed autotours. An Autotour

is a tour created dynamically with the pan, tilt and zoom functions. This

function is not available for the 22X version.

The final menu choice available on the Alarm Input Controller menu is to

Program Alarm Titles. This function and sub-menu are also available from the

Source Titling menu and are reviewed in that section.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 41 42

Sin comentarios

Vicon S10-CH Mini Especificaciones Pagina 22