Vicon S10-CH Mini Especificaciones descargar pdf (Pagina 32)

26 • Competitive Protocols XX134-44-02 Rev 710 SurveyorVFT Camera Dome Programming

Competitive Protocols

SurveyorVFT provides the ability to work with certain competitive protocols. This section briefly describes the use

of the onscreen menu system via specific competitive keypads and protocols. Before using competitive protocols,

DIP switch SW2 must be set to the appropriate protocol. Refer to the latest version of Instruction Manual XX134-

XX for a complete explanation of DIP switch settings. Competitive protocols are not available on ViconNet

(LAN/IP) versions.

1. Set switch 1 on DIP switch 2 (SW2) to the appropriate video mode (PAL/OFF or NTSC/ON).

2. Set switch 2 on DIP switch 2 (SW2) to the OFF position (SERIAL).

3. Set switch 3 on DIP switch 2 (SW2) to the appropriate communication mode (SIMPLEX or DUPLEX).

4. Set switch 4 on DIP switch 2 (SW2) to the appropriate communication protocol (RS-422 or RS-485).

5. Set switches 5-8 on DIP switch 2 (SW2) to the appropriate manufacturer protocol.

Competitive Protocol Switches 5-8

Pelco: Switch 5 is ON, switches 6-8 are OFF (set switch 3 to ON for 2400 baud keypad)

Sensormatic: Switch 6 is ON, switches 5, 7, 8 are OFF

Ultrak: Switches 5 and 6 are ON, switches 7-8 are OFF

Philips: Switch 7 is ON, switches 5, 6, 8 are OFF

Cohu: Switches 5 and 7 are ON, switches 6 and 8 are OFF

Kalatel: Switches 6 and 7 are ON, switches 5 and 8 are OFF

Panasonic: Switches 5 and 8 are ON, switches 6 and 7 are OFF

NTCIP: The dome is specifically coded from the factory or flash upgraded. It cannot

be switched to other protocols without first flashing the firmware back to standard

factory protocol. Switches 5-8 are not used and switch 3 must be OFF for Duplex.

With a SurveyorVFT camera dome connected to the following competitive control systems, operation of the dome

is as follows.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 41 42

Sin comentarios

Vicon S10-CH Mini Especificaciones Pagina 32