Vicon IX 2000 L Información técnica descargar pdf (Pagina 105)

MX Calibration Kit

Vicon MX Hardware System Reference 12-3

This single calibration object can be used for both the dynamic and

static phases of the calibration process, as described in Dynamic

Stage (Camera Calibration) on page 12-8 and Static Stage (Capture

Volume Calibration) on page 12-8.

Table 12-1: MX Calibration Wand Part Descriptions

Key Part Description

1 Marker pillars Attach one of the supplied 14 mm

markers to each pillar.

2 Optional marker

pillar

Attach a 14 mm marker to this pillar if

using as a dynamic calibration wand

wand for real-time MX Camera aiming

in Vicon Nexus.

3 Handle Hold this end when using as a dynamic

calibration wand.

4 Handle extension

(not shown in Figure

12-1)

Attach this to the handle to lengthen

the wand.

5 Fixed foot Align the adjustable feet with this fixed

point when using as a static calibration

object.

6 Adjustable feet Turn the adjuster screw for each foot to

position flat on the floor when using as

a static calibration object.

7 Spirit levels Check the bubbles when adjusting the

feet to ensure object is flat on the floor.

8 Alignment plate

screw holes

Screw each alignment plate into a set

of holes and align the plates with the

edge of a force plate if you are using to

identify the global origin during the

static calibration stage

MXhardware_Reference.book Page 3 Monday, April 30, 2007 1:56 PM

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 255 256

Sin comentarios

Vicon IX 2000 L Información técnica Pagina 105